Yes the session was relatively large.well over 60 tracks at 48k. Yesterday I was on another session and was not monitoring through PT returns.so I don't know. I didn't have time to experiment anymore, but will see if I can repeat the occurence on another session I'm starting mid-day. And no, I wasn't taking crazy pills around really did happen. Last night it seems I could switch back to the stereo aux, and it was fine. I kept the additional (muted) stereo aux input on the session next to the mono returns. I tried using 3&4 inputs and then switched to 5&6, wondering if it was a stereo 'hardware insert' issue with different delays on 3&4.when this didn't work, it did not make sense. I then thought my matched calibration was off on the A/D.switched to another pair, no luck.and when I finally turned of ADC, realized that wasn't the problem.ģ&4 are mono outputs, however there is no 'mono' master fader.and in the I/O all outputs are 'stereo'. I also switched my monitor switcher to monitor direct out of the D2B (Still without the outboard inline, direct into the the 2bus) and it was fine as well. However I took those completely out of the equation to verify that it was not those. I use that to have inline outboard and efx without additional AD/DAs. I created the stereo aux track again, muted it, and the mono auxes were still out.So I then muted the mono auxes, and unmuted the STEREO aux Track.now THAT was fine.Īny ideas on what the ADC is triggering for the Aux Inputs to be out of time.and what is tricking the ADC to get the track back in time when I have multiple aux returns assigned to the same input? So I then deleted the muted stereo aux return (thinking I didn't need it anymore) and the problem came into play with the mono aux returns. I turned off ADC and the problem went away.Īnother work around, is that I created two mono auxes, panned them hard letft and right.and that fixed it. I tried it on a few different stereo returns to have the same result. Aux input 'Analog 3-4, or Analog 5-6'), monitoring out of the 192i/o 1&2.įor some reason, the stereo return is coming back in at slightly different time(mono source smeared across).maybe less than 5ms. I have 14 outputs((6) 192i/o, (8) 888/24i/o) going out and returning to a two track on a stereo aux return(i.e.

Stereo aux return